In the 7500# class only, gas & diesel tractors will compete separately for position, however operate simultaneously within the 7500# class.Ħ. The M-M "G" will be considered a 7500#, 4 plow tractor. , an IHC "M" will not be allowed to compete in the 4500# or 5250# class since it's rated as 3 plow tractor vs a 2 plow of an IHC "H" 2 plow tractor. Plow class will also be assigned to each tractor, e.g. ![]() For classes 9,000 & 10,500, pressed steel rims may be used with a maximum of 18.4x38 tires on a 16" rim. Tire size must have been available as standard or optional equipment for the model of tractor entered. Pressed Steel Wheels -will be allowed however, the correct tire width must be used for the model tractor entered on classes 7500# and below. Safety Hitches - All classes except OPEN will utilize the event-supplied "safety hitch".Ĥ. ![]() The top of the hitch will be 20", measured at weigh-in or at certification.ģ. Fast Hitches (IHC) - Fast Hitches (IHC) must be fixed rigid so as not to be able to move when pulling. However, drawbar hitch pin area should be as level as possible.Ģ. Drawbar pull point can be straight or "drop" configuration drawbar. The minimum distance from the center of the axle to the center of the hitch pin hole will be 18". The top of the drawbar will not exceed 20" measured from the ground. All drawbars will be measured & checked at weigh-in. Drawbars - All classes, except OPEN, will pull from a stock appearing drawbar in a stock mounting location. HOOK FEE PER TRACTOR PER CLASS IS $20.00 CASHĬhanges for 2021 rules shown in Bold Italics.ġ.
0 Comments
Leave a Reply. |